T203.F . Protección contra sobrellenado y sonda de fugas Sonda magnética de inmersión / medidor de nivel WHG overfill protection

Overfill protection for containers

Características

WHG Überfüllsicherung

Familia de productos

Dispositivos de nivel de llenado

Clase de producto

Protección contra sobrellenado y sonda de fugas

Adecuado para

Líquido

Principio de medición

Características importantes

with general approval for construction Z-65.11-404
Low system costs
High chemical resistance

Descripción del producto

Level sensors type T-20_.F... are approved by the DIBt (German Institute for Structural Engineering) as liquid level limit switches for the overcharge protection of containers for storing water-dangerous liquids.

Datos técnicos

Propiedades

Clase de protección: IP 65 Dose

Longitud del tubo deslizante: max. 6000 mm

Temperatura de funcionamiento: max. 135 °C

Presión de funcionamiento: max. 20 bar

Contacto F: 1/12 kΩ

Corriente de conmutación: 1A, 2A

Voltaje de conmutación: 230 V AC

Flotador

Cantidad: max. 6

Tipo 05: Oval Edelstahl 76 mm Ø | Dichte 0,81 g/cm³

Tipo 06: Oval Edelstahl 90 mm Ø | Dichte 0,67 g/cm³

Distancia mínima de contacto: Typ 05: 110 mm | Typ 06: 135 mm

Contactos de conmutación y capacidad de conmutación

Contacto de conmutación: max. 5x | 60 W/VA

normalmente abierto: max. 6x | 100 W/VA

Contacto normalmente cerrado: max. 4x | 60 W/VA

Más información del producto

The floater switches the reed contact mounted in the guide tube when the liquid level rises. The change in resistance in the sensor circuit resulting from the switching operation is evaluated and the output relay triggered.
Parts of the level sensor which get into contact with the media are completely made of PE, PP, PVC, PVDF. So the level sensors T-20_.F... are perfectly suited for being used with tanks for storing highly aggressive media.

The overfill cut-out device consists of the level sensor and the measuring transducer. Our “contact protective relays” type KR-163... and KR-268..., which are also approved by the DIBt, can be used as corresponding measuring transducers (see section 10). The level sensors T-20_.F... can be connected to our “alarm indicators” type OAA-100 and OAA-300.

Easy to install
Sturdy design
Small dimensions
Interference-proof measurement
Switching point adjustable
Various options for connection (connector box / plug / cable)
For usage in category 2 (Ex zone 1) (in combination with [Ex]i contact protective relay KR-163/A/Ex)
Short-line fault / open circuit monitoring (in combination with contact protective relay KR-163... and KR-268... / alarm indicator OAA-100...)
Under the F-contact further optional switching points can be realized
Under the F-contact its also possible to integrate a continuous measurement